Brother BES-1261BC - Manual (Page 120)

Chapter 6 Operation of Machine
BES-961BC • BES-1261BC 118
1. Operating Procedures
1-1 Power Source
• Turn the power on to the machine.
• A message is displayed on the LCD.
• The alarm sounds three times and the needle
bar and the presser foot move upward. Then
the hoop moves to the zero point and the
sewing data screen is displayed.
Note) When turning the power off and back it on again,
wait for at least 10 seconds.
1-2 Preparation for Embroidering
• Select embroidering data.
• Using the jog switches ( ), determine a position to start embroidering.
Note) An error message is displayed on the LCD if a pattern comes out of the hoop.
• Pressing
S T A R T
starts embroidering.
• After embroidering is finished, the machine is placed in the stand-by state.