Brother BES-1261BC - Manual (Page 163)

BES-961BC • BES-1261BC 161
Connection and Installation of Optional Equipment
■ Winding lower thread
t
u
y
r
i
e
o
w
q
1. Turn the power switch on.
2. Set the bobbin
q
in the bobbin winder shaft
w
.
3. Put the thread through the thread guide
e
.
4. Wind the thread around the bobbin
q
several times in the direction of the arrow.
5. Press the bobbin hold
r
.
Note) If the thread cannot be wound evenly, loosen
the screw
t
and move the thread guide
e
right and left for adjustment.
In order to wind more threads around the bob-
bin, loosen the thread
y and move the bob-
bin hold r .
6. After winding is finished, pull out the
bobbin from the bobbin winder shaft and
trim the thread using the thread trimmer
u
.
Note) • If the thread is wound too tight and comes
off from the tension disk, loosen the knob
i . If the thread is too loose, tighten the
knob
i
.
• If the circuit protector
o
functions, the bob-
bin winder motor does not rotate. Leave it
for a while for cooling. Then press the cir-
cuit protector
o . (The thread does not
come out when the motor is not cooled
enough.)