Opticon PHL 2700-RFDC - Manual (Page 22)

U
SER
’
S MANUAL
PHL2700
TERMINAL
/ IRU2700
CRADLE
22
Terminal does not respond to key presses,
while the display stays on.
Message “Application halted” or
“No application installed” is shown.
There is no user’s application for PHL2700
loaded in the terminal. Contact your
supplier.
For example pressing the shift key does
not toggle the shift indicator.
There is a flaw in the application program.
Disconnect the battery pack, and place it
then back in.
The terminal will be in off-state.
Activate the system menu and restart the
application, or download new application.
If problems appears continously contact
the supplier of the user’s application.
Laser stays off, when pressing the
triggerkey.
Power is off.
The triggerkey is no powerkey. Press the
powerkey to get power.
If the terminal is not used the scanner will
switch off all functions.
Press the powerkey to reactivate.
Laser temperature has become too high.
The laser is switched off automatically,
when thelaser temperature becomes
above 50
o C. Wait until the temperature
has dropped.
?
?
?
?
Terminal gets no power, when pressing the
powerkey.
The main battery is exhausted.
Replace the battery pack, or charge the
terminal in the cradle.
Terminal does still not operate and needs a
service
Send the terminal to your supplier for service,
paying attention to the limited warranty.
Indications on the cradle.
Power indicator of cradle is off
No power supply. Check the adaptor.
When the adaptor is good, the cradle
needs service.
Cradle does still not operate and needs a
service
Send the cradle to your supplier for service,
paying attention to the limited warranty.
?
?
7.4 TERMINAL PROBLEMS
7.5 CRADLE PROBLEMS