beautypg.com

Opticon PHL 2700-RFDC User Manual

Page 21

background image

U

SER

S MANUAL

PHL2700

TERMINAL

/ IRU2700

CRADLE

21

When the terminal has a problem with
reading the label:

The resolution of the bar code is too

high.

Decrease the distance between the bar

code and the terminal.

The angle between the label and the

terminal is too high.

Change the angle between the bar code

and the terminal.

The distance is too far or too close.

Change the distance between the bar

code and the terminal.

The bar code is larger than the laser

beam.

Try moving the terminal a bit further away

from the bar code.

The read window is dirty.

Clean the read window of the terminal.

The read window is scratched.

The terminal needs service.

The type of the bar code label is not

enabled.

Enable the bar code symbology in the

application program.

?

?

?

?

?

?

?

When the terminal is placed in the cradle,
the main battery is not charged.

Red LED indicator on the terminal is

flashing on and off.

The charging contacts of the cradle and/or

the terminal are dirty. Clean the contacts.

Red LED indicator on the terminal is not

turned on.

The typical charging procedure requires

the terminal to be switched off. Check this.

The cradle needs a rechargeable battery

pack to charge. When a battery holder for
dry cell batteries Is used, the charger
does not work at all.

There is no contact between the terminal

and the cradle. Try again to place the
terminal properly, or clean the contacts of
either the cradle and/or the terminal.

Replace the battery pack and try again.

The rechargeable battery pack is still not

charged. Red LED indicator on terminal
keeps on.

The charger for the battery pack is

probably defect. The cradle will need
service.

?

?

?

7.2 READ OPERATION

PROBLEMS

7.3 BATTERY CHARGING

PROBLEMS

This manual is related to the following products: