Opticon OPN 2002 v35106 Bluetooth OPN2001 simulation Quick Guide - Manual (Page 8)

8
Additional Bluetooth features
In the Opticon Universal menu book additional Bluetooth features can be found for Opticon barcode
readers with Bluetooth support. Some of these features are also available for this application.
Below these options will be briefly mentioned. For more information and the actual configuration labels
to use these options, please refer to chapter 2.3 of the Universal menu book.
1. Bluetooth connection labels
Below you will find a list of connection control labels, which can be useful to quickly reconnect or
disconnect your OPN2002.
Manually connect
+-CONN-+
Manually disconnect
+-DISC-+
Make discoverable and
connectable
+-DSCO-+
Manually unpair *
+-UNPR-+
* Note: Reading the 'unpair' label will force the OPN2002 to redo the pairing on the next connection
attempt. This can be useful in situations that you don't want unauthorized people to connect your
OPN2002 to your remote device.
In case you're in the situation that you want to connect the OPN2002 to a Bluetooth device, but you
don't have the possibility to print a Bluetooth address label containing the Bluetooth address, then it's
also possible to configure the Bluetooth address using the Universal menu book. The Set/End
Bluetooth address labels can be found in chapter 2.3.1 including more information on how to use
them. The direct input labels of chapter 4.3.3 can be used to enter the 12 digits of the Bluetooth
address.
2. Bluetooth security options
In situations that you want a more secure Bluetooth connection there are a couple of menu options
available for this purpose. Using these options it is possible to change the default passkey (PIN-code),
enable encryption and make authentication mandatory. These options are described in chapter 2.3.2
of the Universal menu book. It's also possible to read the unpair label above to ensure that the
OPN2002 needs to pair again the next time it is used.
3. Trigger-to-connect options
By default the OPN2002 can reconnect by pressing the trigger key for 5 seconds. This option can be
disabled and also the time of 5 seconds can be changed between 1 and 9 seconds.
When you're using the OPN2002 in slave mode, it's also possible to make your OPN2002
discoverable and connectable again by pressing the trigger key by enabling the 'Trigger to make
connectable/discoverable' option.
More information about these options can be found in chapter 2.3.3 of the Universal menu book.