Opticon OPN 2002 v35106 Bluetooth OPN2001 simulation Quick Guide - Manual (Page 6)

6
Connecting to the OPN2002 as slave
When you want a remote Bluetooth device to connect with your OPN2002, then it is not necessary to
configure the remote Bluetooth address, but you will have to make your OPN2002 discoverable and
connectable to allow the remote device to find and connect to your OPN2002.
To make your OPN2002 discoverable and connectable for 2 minutes read the 'Make discoverable and
connectable label' (see also Universal menu book chapter 2.3.1)
Make discoverable and
connectable
+-DSCO-+
It's also possible to press the trigger key for 5 seconds for this purpose, but you will have to change
the default 'trigger to connect' (master) behavior to 'trigger to make connectable'. Read one of the
options below to select the preferred configuration.
Trigger to connect
Trigger to make connectable / discoverable
After you've made the OPN2002 discoverable you can let your remote device discover all Bluetooth
devices in range to find your OPN2002.
Screenshot of discovered Bluetooth devices.
After you've successfully discovered your OPN2002, you can try to let your remote device pair with
your OPN2002.