Opticon OPN 2002 v35412 Batch demo Quick Guide - Manual (Page 9)

9
Loading software on the OPN2002 and OPN2003
Software codes
All OPN2002 and OPN2003 terminals run an OS (operating system) and an
application. Both the OS and the application can be loaded by a small PC
application called Appload, which can be download from our web site.
The OPN200x terminals use an Operating System version that contains an
unique 3 letter code. Before you try to load a new Operating System on an
OPN200x terminal you have to know which Operating System file (i.e.
RBFVxxxx.S2) must be loaded on your terminal.
In the table below you can find the software codes for the OPN200x terminals.
Terminal OS Application
OPN2002 RBG RFG*
OPN2003 RBF RFF*
* It is often possible to load OPN2002 applications on the OPN2003 and vice
versa, because the hardware is mostly the same (besides Bluetooth capabilities
and cradle contacts that are only present on the OPN2002).
USB Driver
To be able to communicate with the OPN200x terminals using USB, you will need
to have its USB driver installed on your PC. This driver can be found on our web
site on the 'Service and Support' page.
www.opticon.com/SERVICE-AND-SUPPORT.aspx
The driver can be found in the section called 'Software' and then selecting the
OPN2002 or OPN2003.
Two drivers can be downloaded for the OPN200x:
optousb32.exe
USB driver for Windows 2000, Windows XP (32bit),
Windows Vista (32bit), Windows 7 (32 bit)
optousb64.exe
USB driver for Windows XP (64bit), Windows Vista (64bit),
Windows 7 (64 bit)
After installing the USB driver, you can connect your OPN2002 or OPN2003 to an
USB port using a mini-USB cable. Windows will then automatically install a
virtual COM port on your PC, which can be selected in various applications, like
Appload, Hyperterminal and Neto32.