Opticon OPN 2002 v35412 Batch demo Quick Guide - Manual (Page 3)

3
Customizing your OPN2002 and OPN2003
OSE Universal Menu Book support
After loading this software on the OPN2002/3 for the first time, the application
will automatically be reset to default. If needed, reading the following default
label will also reset the application*
(The label below can be read without reading any SET/END labels)
OSE Handheld terminal
default (RS232 / USB)
In contrary to other Opticon hand held terminals, the OPN2002/3 also supports
the reading of various configuration options that can be found in our Universal
menu book**. This makes it possible to customize your application without
having to actually change the source code of this demo software.
The OPN2002/3 supports (most of the) menu options listed in the following
chapters:
1. Defaults (See the supported default label listed above)
3.1 Enabling/disabling readable codes
3.2 Setting of fixed, minimum and maximum lengths of readable codes
3.3 Code specific options (most options are supported except 2D symbology
options)
4.1 Case conversion
4.2 Set prefixes
4.3 Set suffixes
5.1 Read modes, add-on wait modes
5.1.1 Multiple read reset time
5.1.2 Quite zone options (margins)
5.2 Read time options
5.4 Redundancy
5.5 Positive and negative barcodes
6.1 Buzzer settings
6.2 Good read LED options
7.1 Diagnostics
* This demo application does not implement any of the OPN2002s Bluetooth
capabilities. A Bluetooth demo (RFG35312) for the OPN2002 is available on our
web site that demonstrates its Bluetooth capabilities.
** The Universal Menu Book can be downloaded from our web site.