Opticon OPN 2002 v35412 Batch demo Quick Guide - Manual (Page 5)

5
Deleting the database file from the internal RAM disk
It might be possible that your OPN2002/3 has a full or corrupt RAM disk or
contains unwanted barcode data that you want to delete from the OPN2002/3.
In this situation it is possible to read the label below to erase all files from the
RAM disk.*
_+-FORMAT-+_
* Note: If the battery of the OPN2002/3 goes dry, then the OPN2002/3 won't
immediately loose it's barcode data. However, after a few days after becoming
empty all data on the RAM disk will be lost. Also the internal clock will reset if the
battery is completely drained. This requires the correct time to be reconfigured
using Appload.
Installing the USB driver
To be able to communicate with the OPN200x terminals using USB, you will need
to have its USB driver installed on your PC. This driver can be found on our web
site on the 'Service and Support' page.
www.opticon.com/SERVICE-AND-SUPPORT.aspx
The driver can be found in the section called 'Software' and then selecting the
OPN200x on the following page.
Two drivers can be downloaded for the OPN200x:
optousb32.exe USB driver for Windows 2000 , Windows XP (32bit) & Windows Vista/7 (32bit)
optousb64.exe USB driver for Windows XP (64bit) & Windows Vista/7 (64bit)
After installing the USB driver, you can connect your OPN2002 or OPN2003 to
USB using the mini-USB cable. Windows will then automatically install a virtual
COM port on your PC, which can be selected in various applications, like
Appload, Hyperterminal and Neto32.