Opticon H19А User Manual
Page 33
Entering Symbols
To enter special symbols and accented letters (e.g. а, З, ®…etc.), do the following:
1. After pressing a character (e.g. E), press the Fn key and then the numeric key 0 once to show
an accented type of this character (È).
. To show another accent type, press and hold the Fn key and then press the numeric key 0
repeatedly until desired type is displayed (e.g. press numeric 0 three times to show Ê).
• Fn + : switch to Initial capital mode.
• Fn + : switch to Uppercase mode.
• Fn + Action key (the central button of the -way navigation key): perform Enter.
• Fn + * (
): this is set to open Start menu by default (Programable Button ). Refer to
chapter .1 if you want to change it.
• Fn + # (
): this is set to perform OK/Close by default (Programable Button ). Refer to
chapter .1 if you want to change it.
• Fn + Record key (on the left side of your device): lock/unlock the device.
Corresponding letters/symbols for each character:
a
а б в д е ж г ą ă
i
м н о п ĩ ij
A
А Б В Д Е Ж Г Ą Ă
I
М Н О П Ĩ IJ
c
ç ć ĉ ©
l
ł
C
Ç Ć Ĉ ©
L
Ł
d
ð
n
ñ
D
Đ
N
Ñ
e
и й к л ę
o
т у ф х ц ő ø œ