Opticon DWT 7133 - Manual (Page 3)

Opticon user's manual
When placing the terminal on the cradle,
make sure that the terminal is placed fully
inwards the cradle. If the terminal is not
placed correctly there is no contact with the
cradle, and as a result communication or
charging activity is not possible.
The following points should be observed:
The reading tip of the terminal will be
placed inwards the cradle.
The clip on the backside of the terminal
should fit into the saving on the cradle.
The terminal is pressed with slight force
into the direction of the cradle untill it fits
properly.
Typically the yellow gasket at the top of the
terminal should align with the edge of the
cradle.
U SER ’ S MANUAL DWT 7133
5
U SER ’ S MANUAL DWT 7133
4
Before you begin your installation, be certain
that you have all the items listed below:
This manual.
The DWT7133 pen terminal.
If ordered: The DCW9931 cradle
(including powercable)
If ordered: Connection cables.
Remove the packaging and check for any
physical damage. We recommend you to save
all packaging: it should be used whenever you
need to transport your terminal for service.
Damage caused by improper repackaging is
not covered by the warranty.
THE DWT7133
3
1
1. Reading Tip
An optical reader for bar codes.
2. Activation key definable by user’s application
Typical use: Enables the user to activate
the bar code reader.
3. Bi-colour signalling LED
For visual indication of the bar code
reader's operation (lights up green or
red). To be defined by the user.
4. Up key definable by user’s application
Typical use: Menu scroll key upwards.
5. Down key definable by user’s application
Typical use: Menu scroll key downwards.
6. LCD display
Displays e.g. bar code data, host
messages and user instructions or user
data.
7. Optical Window
Window for optical data transmission.
8. Product label
Do not remove this label!
* A rechargeable battery and beeper are
inside the terminal.
See figure 1.1.
The DCW9931 cradle must be used to upload an
application program to the DWT7133 terminal.
Data transmission to a host system (PC or
network) can be achieved by using the
DCW9931 cradle. Thanks to the flexibility of
the DCW9931 cradle it is possible to connect
one single terminal to a host computer or
implement several terminals in a network
structure. The cradle supports both RS232
and RS485 communication.
See figure 1.2.
1.1 COMPONENTS DWT 7133
1.2 CRADLE DCW 9931
DW
T
6
5
4
3
2
1
Figure 1.1 Components of the DWT7133
8
7
Figure 1.2 The DCW9931 cradle
1.3 TERMINAL ON CRADLE
Figure 1.3 Placing the terminal on the cradle