Multiquip DCA150SSJU3 - Manual (Page 25)

DCA150SSJU3 50 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #1 (02/01/10) — PAGE 25
DIAGNOSTIC DISPLAY
Shutdown Codes
1. During normal operation the single or four parameter
screen will be displayed
2. When the diagnostic display receives a severe fault
code from an engine control unit the single or four
parameter screen will be replaced with the “Shutdown”
message.
3. To acknowledge and “Hide” the fault and return to the
single or four parameter display touch the “Enter Button”.
4. . The display will return to the single or four parameter
display, but the display will contain the “Shut Down”
icon. Touching the “Enter Button” will redisplay the
hidden fault.
SPN110 FMI10
HIGH COOLANT TEMP
SHUTDOWN 1 of x
MORE HIDE
SPN110 FMI10
HIGH COOLANT TEMP
SHUTDOWN 1 of x
MORE HIDE
5. Touching the “Enter Button” once again will hide the
fault and return the screen to the single or four
parameter display.
6. The Single or Four parameter screen will display the
fault icon until the fault condition is corrected. NOTE:
Ignoring active fault codes could result in severe engine
damage.
Bachlight Adjustment
1. Starting at the single or four engine parameter display
touch the “Menu Button”.
2. The main menu will pop up on the display. Use the
“Arrow Buttons” to scroll through the menu until the
“Adjust Backlight” is highlighted.
SPN110 FMI10
HIGH COOLANT TEMP
SHUTDOWN 1 of x
MORE HIDE
GO TO 1-UP DISPLAY
STORED CODES
G ENGINE CONF
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
ADJUST BACKLIGHT