Multiquip DCA150SSJU3 - Manual (Page 23)

DCA150SSJU3 50 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #1 (02/01/10) — PAGE 23
2. The main menu will pop up on the display. Use the
“Arrow Buttons” to scroll through the menu until the
“Engine Confi guration” menu item has been highlighted.
3. Once the “Engine Confi guration” menu item has been
highlighted touch the “Enter Button” to view the engine
confi guration data.
4. Use the “Arrow Buttons” to scroll through the engine
confi guration data.
5. Touch the “Menu Button” to return to the main menu.
6. Touch the “Menu Button” to exit the Main menu and
return to the engine parameter display.
GO TO 1-UP DISPLAY
STORED CODES
ADJUST BACKLIGHT
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
ENGINE CONFG
GO TO 1-UP DISPLAY
STORED CODES
ADJUST BACKLIGHT
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
ENGINE CONFG
FAULTS AND WARNING
Auxiliary Gage Fault
1. During normal operation the single or four parameter
screen will be displayed.
2. The PVA Series of auxiliary gages can be attached to
the PowerView. These auxiliary gages communicate
with the Modbus master PowerView via a daisy-chained
RS-485 port. If at any time during system initialization
or normal operation an auxiliary gage should fail, the
single or four parameter screen will be replaced with
the “MLink Gage Fault” message.
3. To acknowledge and “Hide” the fault and return to the
single or four parameter display, touch the “Enter
Button.
4. The display will return to the single or four parameter
screen.
ENGINE OIL PRESSURE
GAGE NOT RESPONDING
1 of x
HIDE
ENGINE OIL PRESSURE
GAGE NOT RESPONDING
1 of x
HIDE
DIAGNOSTIC DISPLAY