MTS Criterion Series 40 - Manual (Page 31)

Description Control / Screen / LED Number
Makes fine adjustment of the crosshead. Moving the wheel
towards the display moves the crosshead up; moving the Thumb-Wheel 4
wheel away from the display moves the crosshead down. The
handset must be enabled for the thumb-wheel to be active.
Pauses the test action. Press this button again for the test to
resume. Testing software must be active. Pause 5
Stops the test action. Testing software must be active. Stop 6
RJ-45 connection to the controller. Connector 7
Returns the crosshead to the original position (zero point). Crosshead Return 8
Starts the test action. Testing software must be active. Start 9
Moves the crosshead in the downward direction while
depressed. Handset must be enabled. Crosshead Down 10
Moves the crosshead in the upward direction while depressed.
Handset must be enabled. Crosshead Up 11
When illuminated, indicates an active fault or interlock. Fault 12
Used to enable/disable the handset. When the indicator is
illuminated, the handset is enabled to control movement of
the crosshead. Handset Enable 13
Shows four lines, 20 characters per line. Display 14
Safety Enclosure (Optional)
The optional safety enclosure is used to avoid projectile hazards and to facilitate safe system operation
by preventing body parts from entering crush zones during tests.
MTS Criterion ™ Series 40 | 31
System Introduction