MTS Criterion Series 40 - Manual (Page 136)

Decommissioning
The decommissioning process is performed when the system is going to be moved or taken out of service.
Disassembly is required when performing either of these tasks. To decommissioning the system:
1. Remove the specimen and fixtures. Large grips should be removed if the load frame could be tipped
over.
2. Isolate the system from electrical power.
3. When the system electronics, control software, and the system PC are powered down, turn off the
system’s main electrical supply.
4. Disconnect all cables from the controller.
5. Cover the material testing machine with a dust cover, such as plastic foil. Allow for sufficient ventilation
or place a dehumidifier near the equipment.
6. Place the accessories and the instruction manual in a clean, dust protected place, such as a tool cabinet.
Warning :
Electrical components and parts can contain hazardous chemicals and compounds.
Improper disposal of hazardous chemicals and compounds can cause injury and death to
people, animals, and plants. In addition, it can cause contamination of the soil, air, and
water.
Always refer to local codes that govern the disposal of potentially hazardous materials and
follow these codes for the proper handling and disposal of these materials.
136 | MTS Criterion ™ Series 40
Decommissioning