MK Diamond MK-2005G - Manual (Page 44)

MK-2005G Revision 12/00, Effective Date December 26, 2000 Page 44
MAINTENANCE AND TROUBLESHOOTING
NOTE: DO NOT use a screwdriver when installing new belts.
(G)
Remove the V-belt
(I)
Verify the V-belt is seated in
The grooves of both pulleys
(H)
Install the new V-belt
(MK Diamond Part No. 156294)
(J)
Verify the Engine Adjustment
Strap Lock-nut is loose then
tighten the Adjustment Strap
(L)
Continue adjusting V-belt until
tension is correct then tighten the
Engine Adjustment Strap Lock-nut
(K)
Check V-belt tension
(proper tension 1/8-inch)
(M)
Check V-belt tension
(proper tension 1/8-inch)
(N)
Tighten Base Plate
(O)
Install the Belt Guard
V-belt V-belt
Pulley
Turn clockwise
to tighten
Check Tension
1/2-way
between pulleys
Turn clockwise
to tighten
Check Tension
1/2-way
between pulleys
1/2-inch
Wrench Turn clockwise
to tighten
Retaining Bolts
1/2-inch
Wrench
Turn clockwise
to tighten