MK Diamond MK-2005G - Manual (Page 25)

MK-2005G Revision 12/00, Effective Date December 26, 2000 Page 25
SETUP, STARTUP, ADJUSTMENT, OPERATION and SHUTDOWN
SHUTDOWN:
1. Normal Engine Shutdown:
2. Emergency Engine Shutdown:
3. Cleanup:
Engine parts are extremely hot following use, allow engine to cool 1/2-hour before cleaning. Use
care during cleanup to avoid injury.
NOTE: If a clean external water source was used, steps A to C may be skipped.
(B)
Place Engine Switch
in the OFF position
(A)
Move the Throttle Lever to lower
blade speed
(C)
Place Fuel Valve in the
OFF position
(B)
Move the Throttle Lever to lower
blade speed
(A)
Place Engine Switch
in the OFF position
(C)
Place Fuel Valve in the
OFF position
(B)
Place Water Pump in a
container of clean water
(A)
Clean Water Pump
suction of all debris
(C)
Run MK-2005G until clear water
is seen at blade cooling ports
(Approx. 1 minute)
Fuel Valve
Throttle Lever
Engine Switch Direction of
Movement
Engine Switch Direction of
Movement
Throttle Lever
Fuel Valve
Direction of
Movement
Direction of
Movement
Pump Suction Water Pump
Water Container
Cooling Flow
Points
Direction of
Movement
Direction of
Movement