MK Diamond MK-2005G - Manual (Page 12)

MK-2005G Revision 12/00, Effective Date December 26, 2000 Page 12
UNPACKING, TRANSPORT, UNIVERSAL STAND and ASSEMBLY
4. Diamond Blade Installation:
NOTE: When installing the diamond blade retaining-bolt, ensure the threads of the bolt are aligned with the
threads of the drive shaft so as not to “cross-thread" the bolt.
5. Water Pump Installation:
NOTE: The Belt Driven, Flexible Shaft Water Pump is locked in the shipping position from the factory. It will
need to be removed from between the left Upright Casting and the Cutting Head to allow free movement of
the Cutting Head.
(C)
Install Diamond Blade
onto Blade Shaft
(B)
Identify and remove Retaining
Screw and Outer Flange
(A)
Raise Cutting Head
(E)
Install Retaining Screw and
Outer Flange then tighten
(D)
Verify Blade is seated on Blade
Shaft in correct rotation direction
(C)
Remove Water Pump Assembly
from between left Upright
Casting and Cutting Head
(B)
Loosen and remove Water
Pump retaining clamp,
wing nut and bolt
(A)
Loosen and remove Water
Pump adjustment clamp,
wing nut and bolt
Cutting Head
Loosen Locking
Handle to adjust
Cutting Head
Retaining Screw
and Outer Flange
Turn counter-
clockwise to
loosen
Blade Wrench Install
Blade
Rotation Direction
Seat Blade on
Blade Shaft
Rotate Blade
Wrench clockwise
to tighten
Retaining Screw
and Outer Flange
Loosen Wing Nut
Remove Water Pump Loosen Wing Nut
7/16-inch
Wrench
Remove Water
Pump from Clamp
Cutting
Head
Upright
Casting
Water
Pump