MK Diamond MK-2005G - Manual (Page 22)

MK-2005G Revision 12/00, Effective Date December 26, 2000 Page 22
SETUP, STARTUP, ADJUSTMENT, OPERATION and SHUTDOWN
(I)
Move the Throttle Lever to lower
blade speed
(F)
Move the Throttle Lever to
adjust blade speed (faster blade
speed for smoother cuts)
(E)
Verify cooling flow exists on
both sides of the blade
(D)
Open the Cooling Flow Control
Valve and adjust flow
(H)
Slowly push piece toward the
blade – continue until the
cut Is complete
(G)
Setup to Cut
(K)
Raise Cutting Head once
cut is complete
(J)
Unlock Cutting Head
Direction of
Movement
Control Valve
Direction of
Movement
Hold Work
in Position
Push Slowly to Cut
Direction of
Movement
Unlock Cutting
Head
Loosen Locking
Handle to adjust
Cutting Head
Raise Cutting
Head
Cooling Flow
Points Throttle Lever
Throttle Lever