MK Diamond MK-2005G - Manual (Page 16)

MK-2005G Revision 12/00, Effective Date December 26, 2000 Page 16
SETUP, STARTUP, ADJUSTMENT, OPERATION and SHUTDOWN
2. Water Pump Setup:
The Water Pump can be setup in three ways, External Water Source, Re-circulation or Un-coupled for dry
blade operation.
NOTE: To extend the life of the Diamond Blade and Water Pump, MK Diamond recommends a clean cooling
water source when using a Wet Diamond Blade.
I. External Water Source:
This is the preferred method of cooling when using a "wet" diamond blade.
II. Re-circulation:
NOTE: 1. Water Pump could interfere with masonry being cut.
2. Water should be periodically replaced when using this method.
(C)
Place the Water Pump
Assembly into an External
Water Source Container
(B)
Loosen and remove Water
Pump adjustment clamp,
wing nut and bolt
(A)
Verify Water Basin is inserted
into the MK-2005G and
remove the Drain Plug
(D)
Fill the External Water Source
Container and place a Catch
Basin below the Drain Hole
(C)
Place Water Pump on Pump
Stand molded into Water Basin
(B)
Loosen Water Pump adjustment
clamp wing nut and bolt
(A)
Verify Water Basin is inserted
into the MK-2005G and
install the Drain Plug
Loosen Wing Nut Drain Plug Water Basin Water Pump
Water Container
Clean Water
Drain Plug Water Basin Loosen Wing Nut
Remove Water Pump
Molded Stand
Water Pump