MK Diamond MK-2005G - Manual (Page 15)

MK-2005G Revision 04/2003, Effective Date April 2, 2003 Page 15
SETUP, STARTUP, ADJUSTMENT, OPERATION and SHUTDOWN
SETUP:
1. Pre-start Inspection:
The pre-start inspection should be performed before beginning any job.
If the Diamond Blade shows signs of fatigue cracking, replace the blade before starting work.
(C)
Verify Movable Cutting Table
moves freely
(B)
Inspect Wooden Strip for
excessive grooves
(A)
Inspect Blade for damage –
Verify Blade correct for material
being cut
(F)
Check for proper oil level
(See Maintenance section if low)
(E)
Inspect MK-2005G for general
damage, loose connections
and hardware
(D)
Inspect Engine for leaks
(H)
Check Air Filter for cleanliness
(See Maintenance section
if dirty)
(G)
Check for proper fuel level
(See Maintenance section if low)
Cracks
Replace if Excessively Grooved
(See Maintenance Section)
Verify Ease of Movement
(See Maintenance Section)
Look for leaks
Inspect for
damage
Proper Oil Level
Low Level
Upper Limit
Fill Throat Air Filter