MK Diamond MKDX Profile Milling Machine - Manual (Page 7)

7
• This equipment should not be operated by persons under 18 years of age.
• NEVER operate this equipment without proper protective clothing, shatterproof glasses, steeltoed
boots and other protective devices required by the job.
• NEVER operate this equipment when not feeling well due to fatigue, illness or taking medicine.
• NEVER operate this equipment under the influence of drugs or alcohol.
• Whenever necessary, replace nameplate, operation and safety decals when they become
difficult to read.
• ALWAYS check the machine for loose bolts before starting.
• ALWAYS store equipment properly when it is not being used. Equipment should be stored in a clean,
dry location out of the reach of children.
• CAUTION must be observed while servicing the machine. Rotating parts can cause injury if contacted.
• Ensure that any electrical extension cord is protected against damage. Always ensure that the
electrical extension cord is not trapped underneath the machine.
• DO NOT allow extension cord to come into contact with water or fluids. DO NOT spray water onto electric motor.
MKDX SAFETY
Failure to follow instructions in this manual may lead to serious injury or even death! This equipment is
to be operated by trained and qualified personnel only! This equipment is for industrial use only. The fol-
lowing safety guidelines should always be used when operating the MKDX Bullnose & Shaping Machine.
GENERAL SAFETY
DANGER
RULES FOR SAFE OPERATION
ON / OFF • NEVER leave the machine unattended. Turn off electric motor when unattended.
• NEVER operate the machine in an explosive atmosphere.
• ALWAYS wear proper respiratory (mask) hearing and eye protection
equipment when operating this machine.
• DO NOT operate or service this equipment before reading this entire manual.
• Before starting the machine, check that all guards are in position and correctly fitted.
• Keep area around the machine clear of obstructions which could cause persons to fall onto moving parts.
• ALWAYS ensure that the machine is on level ground before using.
• Become familiar with the controls of the machine before operating.