MK Diamond MKDX Profile Milling Machine - Manual (Page 19)

19
MKDX UNPACKING & MACHINE SET-UP
1. Remove carton top and shipping strap.
2. Remove machine from pallet and place onto flat surface. Check for broken or damaged parts.
3. Remove material slide.
4. Take the stand out of box. Remove the legs and insert into stand.
5. Place knobs in threaded portion and tighten against leg. Legs can be slid up and down and
locked in place for a level profile machine.
6. Two people can now lift the MKDX machine onto the set up stand.
• Before using the machine, check for any broken, worn or damaged parts and replace them
immediately.
• ALWAYS keep the machine clean and lubricated.
• ALWAYS unwind the power supply cord completely and check for damage.
• Carefully check the “Technical Data” Label before plugging in the machine. Follow the extension
cord requirements, as recommended on the machine label.
• Work on a level and clean surface.
NOTICE
Two people are recommended to move and set up this machine.
WARNING
UNPACKING & MACHINE SET-UP