MK Diamond MKDX Profile Milling Machine - Manual (Page 12)

12
The MKDX is equipped with a number of safety decals provided for operator safety and maintenance
information. Should any of these decals become unreadable, replacements can be obtained by call-
ing (800) 262-1575.
Fig. 6 MKDX Safety Decal Sheet, Part No. 166256
OPERATION & SAFETY DECALS
SERVICE OR
WARRANTY
FOR INFORMATION ON
PLEASE CALL
1-800-474-5594
MKDX SAFETY
WARNING
Grinding/cutting/drilling of masonry, concrete, metal and other materials with silica in
their composition may give off dust or mists containing crystalline silica. Silica is a basic
component of sand, quartz, brick clay, granite and numerous other minerals and rocks.
Repeated and/or substantial inhalation of airborne crystalline silica can cause serious
or fatal respiratory diseases, including silicosis. In addition,California and some other
authorities have listed respirable crystalline silica as a substance known to cause cancer.
When cutting such materials,always follow respiratory precautions.
!
Decal C
Decal D
Decal E
Decal G
Decal A Decal B
Decal H
Unlock locking
screw before using
NOTICE !
CAUTION
DO NOT
operate without
guards in place.
!
NOTICE
Overtensioning of belts
will result in premature
crank and/or bearing failure.
!
DO NOT operate
this equipment
before reading
the owners’
manual!
WARNING !
Most Motor Problems are caused by improper
voltage and extension cords. Cord should be
one-piece and short as possible. Cord
selection should match the following table.
1-2 H.P.
25’
50’
75’ 100’
150’
250’
Max. Cord Length
Max. Cord Length
Max. Cord Length No. 12 Wire
No. 10 Wire
No. 8 Wire
115v 230v
NOTICE
!
!
Loosen locking screw before
adjusting. Retighten before
operation.
AU
Decal F