Maintenance and troubleshooting – MK Diamond MK-770 EXP User Manual

Page 39

MAINTENANCE AND TROUBLESHOOTING

“Rodding” cooling channels is performed by inserting a small wire rod through the cooling inlet on top

of the Blade Guard and directing the rod out through each of the cooling flow tubes located on the

underside of the Blade Guard. The cooling channels should be “rodded” until all ports are free of foreign

debris.

NOTE:

(K)

Rod Cooling Channels and

recheck flow

(J)

Clean the Blade Guard Intake

Fitting

4. Blade Stops Turning

(A)

Verify all plugs are fully

installed

(C)

Check power source voltage

is 115V – if not 115v, move to

another circuit

(B)

Verify circuit breaker not

tripped If tripped, reset once