MK Diamond MK-770 EXP - Manual (Page 24)

24
SETUP, ADJUSTMENT & OPERATION
4. Off-angle Cutting:
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for which it was
designed.
(B)
Place the Protractor on the
Ruler/Stop
(A)
Remove the Adjustable
Cutting Guide
(C)
Set the desired angle on the
Protractor Gage
(E)
Position the Protractor Cutting
Guide to the desired length
(D)
Tighten the Protractor Gage
retaining knob
(F)
Tighten the retaining knob
(H)
Turn the motor ON
(G)
Position the tile against the
Protractor and the Ruler/Stop
(I)
Verify cooling flow on both
sides of the blade
(G)
Perform the cut
(H)
Turn the motor OFF when
work is complete
Adjustable
cutting guide
Ruler/Stop
Turn CCW to
loosen
NOTE: Use a Protractor (MK Part No. 134569-MK) should be used (not included).
CAUTION