MK Diamond MK-770 EXP - Manual (Page 33)

33
(E)
Check for Gap between the
Square and Straightedge
(D)
Move Straightedge to the other
side, and place the Square on
that side of table
(F)
If Gap exists, loosen Movable
Cutting Table Wheel Assembly
Blade Guard retaining
wing nut
Straightedge
Lock
MAINTENANCE AND TROUBLESHOOTING
This will verify the Movable Cutting Table is aligned to the frame of the saw.
NOTES: If the blade is misaligned following alignment verification, attempt to align using Alignment Screw, 90º
Verification. The Diamond Blade must be removed and reinstalled when removing the Blade Guard.
(B)
Place straight edge on frame
and Square on cutting table
(A)
Remove Blade Guard
(C)
Lock in position
(H)
Re-Verify Wheel Assembly side of
Movable
Cutting Table height
is same as Guide Bar side
(G)
Move Wheel Assembly up or
down to Square the Movable
Cutting Table
(I)
Tighten Movable Cutting Table
Wheel Assembly
Movable Cutting Table Alignment Verification:
Adjust Square until
Resting on Straightedge
No Gap