Memmert HCP 246 Humidity Chambers (Generation 2003) - Manual (Page 16)

HCP page 16
8 Weekly programmer
In this operating mode the weekly programmer is activated and the oven switches on and off automatically
at the programmed times.
While the weekly programmer is in the OFF phase the unit is in stand-by mode. Heating and the supply of
humidity are switched off, the controller display is dimmed and shows the clock time.
The sequence of the weekly programmer is repeated every week.
A maximum of 9 time blocks, each consisting of ON time and OFF time, can be programmed.
By rotating the push/turn control the following parameters can be selected and can be altered as described
in the section 6:
Weekday
Adjustement range: Monday to Sunday
Mo Tu We Th Fr Sa Su
Day groups
Adjustement range: weekend Sa-Su
weekend Sa-Su
Mo Tu We Th Fr Sa Su
Mo Tu We Th Fr Sa Su
No ON time: ----
On these days the oven is not switched on
(without an ON time being entered, an OFF time cannot be
programmed for the respective time block either)
on
off
ON time
Adjustment range: 00.00 to 23.59 hrs.
on
off
OFF time
Adjustment range: one minute above ON time to 24.00 hrs
on
off
Further clockwise rotation selects the parameters (temperature and humidity setpoint etc.) as under
operating mode I.
If no settings (temperature and humidity setpoint etc.) are made for the ON phase, the controller takes the
values from operating mode I.
For safety reasons, always check that an ON time has been programmed only during the required time
blocks and days.
Direct setting of the temperature setpoint
When the controller is in stand-by mode or if the weekly programmer is in the ON phase, the temperature
setpoint can be selected directly by briefly pressing the SET key. Further clockwise rotation reaches
temperature monitor and humidity adjustment. Anticlockwise rotation reaches again adjustment of the
individual time blocks.
PRINT SETUP
on
off
Mo Tu We Th Fr Sa Su