Loadstar Sensors DS-3000 Digital Load Cell Display & Controller - Manual (Page 22)

DS-3000U DS3000 User Guide
Loadstar Sensors, Inc. Page: 22 / 48 033-01419 Rev. 4
8
COMMAND REFERENCE
8.1
Run Mode Command Descriptions
Run mode is when the DS-3000 is currently displaying load on the display, and is not awaiting any user
input. This is the default state. All run mode keystrokes have an immediate effect on the displayed value.
8.1.1 Tare All Sensors
Function: TARE ALL
Keystrokes: Press key enter until t.a.r.e... is displayed, then release. Displayed
decimal points correspond to currently active sensors.
Summary: Tare all connected and active sensors simultaneously.
8.1.2 Set Displayed Units
DISPLAY UNITS
Keystrokes: Press key up until the desired units LED is illuminated. Options are US Pounds
(Lb), Kilograms (Kg) and Newtons (N).
Summary: Display the current load value in the selected units.
8.1.3 Enter Programming Mode
Function: PROGRAM MODE
Keystrokes: 1. Press menu
2. Display will show enter pass
3. Press up or down to change the value of the currently highlighted digit,
and menu selects which digit is currently highlighted. Enter the correct
password value (default is 000001)
4. Press enter
5. Now pressing menu will step through the programming mode pages.
Summary: Switch from run mode to programming mode.
8.1.4 Change Display Precision Mode
Function: SPECIAL FUNCTIONS
Keystrokes: To Manually select the display precision:
1. Press the down button (bottom right) and holding it down, press
enter (bottom left).
2. Now release the down button while continuing to hold down enter.
3. While continuing to hold enter press up (top right) or down (bottom
right) to select your desired decimal point location. The current
decimal point location is illuminated on the display while you