Let's Go Aero LittleGiant Trailer LGT 1107 - T (Torsion based model) - Manual (Page 16)

– 16 –
l
iTTle
G
ianT
T
railer ™
LGT1107rev0614
11. Secure Side Panels
Use the pre-drilled holes on the side panel where
it starts to curve as a guide, install sixteen (16)
Self Drilling Screws (Z) to secure the side panels
to the U-Tubes. For best results apply only a little
pressure when installing the screws. Repeat on
opposite side.
10. Install Body Fastners
Locate the twelve (12) Self Drilling Screws (Z) and twelve (12) 1” Flat Washer. Use the pre-drilled holes in the center
of the floor panels and at front and rear center of panel locations as a guide to engage and tighten the self drilling
fasteners though the floor panels and into the U-Tubes with an electric drill and a Phillips head.
12. Install Side Body Latches
Use the holes in the outside of the #1 and #8 U-Tubes
as guides to install 1" End Gate Latch (U) in these
holes on the outside of the U-Tubes using eight (8)
5/16” x 1-3/4” Bolts (DD), 1/4” Flat Washers, and 5/16”
Nylon Lock Nuts.
1" End Gate
Support Bracket (V)
1/4” Flat Washers
& 5/16” Nylon
Lock Nuts
5/16” x 1-3/4” Bolt
(LL)
Self Drilling Screws used
to secure side panels