Let's Go Aero LittleGiant Trailer LGT 1107 - T (Torsion based model) - Manual (Page 13)

– 13 –
l
iTTle
G
ianT
T
railer ™
LGT1107rev0614
6. Install Wheels
Install the wheels on the axle. Tighten the lug nuts to 50 to 75 foot pounds. Refer to the Wheels and Tires Section
of this manual. After using the trailer for 50 miles, re-check the lug nuts to insure they have remained tight.
Tighten Lug Nuts
to 50 – 75 ft. lbs
5. Install A-frame Coupler and Safety Cables
Locate the A-Frame Coupler (D), the two (2) Safety Cables (E), two 1/2” X 3” Bolts (AA), two (2) 1/2” X 3-1/2” Bolts,
four (4) 1/2” Nylon Lock Nuts (CC) and six (6) 1/2” Flat Washers (BB), and two (2) 1/2” Bigger Flat Washers for
Safety Cable area as noted below.
Attach the A-Frame Coupler (D) to one of the A-Frame tubes and install the Safety Cable in the front hole of the
coupler. Install two 1/2” X 3” Bolt, two 1/2” Nylon Lock Nut and four 1/2” Flat Washers on of the coupler to attach it
to the A-Frame Tube. Using two 1/2” X 3-1/2” Bolt, two 1/2” Nylon Lock Nut, two 1/2” Flat Washers and two bigger
washer instally safety cable on the coupler Tighten this hardware for Assembly Fit (Tighten later).
4-Flat Wire Lighting Harness
with Four-Flat Connector
A-Frame
Coupler (D)
Safety Cable (E)
1/2” Flat
Washer
(BB)
1/2” Flat
Washer (BB)
Bigger Washer
1/2” X 3” Bolt
1/2” X 3”
Bolt (AA)
1/2” Flat
Washer (BB)
1/2” X 3-1/2” Bolt