Let's Go Aero LGT 4 Tongue Extension ACC 3070 - Manual

LGT 4’ Tongue Extension
User Installation Instructions
ACC 3070
Tools Needed
Ratchet
¾” socket
¾” wrench (2)
9/16” wrench or socket with extension
Assembly
Lift coupler handle up to the unlocked position.
While pushing down on handle to compress the
Coil Spring, use a 3/4” racket to remove the lock
nut.
Step 1: Disassemble A-frame coupler
Remove the saftey cables on the coupler by removing the
bolts. Place the bolts back as shown.
Step 2: Remove Safety Cables
Parts List
Description Qty Description Qty
16” Tongue Tube 1 3/8 Split Lock Washer 2
72” Tongue Tube 1 ½-13 x 6-1/2 Hex Cap Screw 1
Coupler 1 ½-13 Nylon Insert Lock Nut 6
Wire harness extension 1 ½ USS Flat Washer 11
Hat Bracket 1 ½-13 x 5 Hex Cap Screw 2
Coupler Plate 1 ½-13 x 1 Hex Cap Screw 1
Wire Tie 1 ½-13 x 3-1/2 Hex Cap Screw 1
3/8-16 x 1 Hex Cap Screw 2 ½-13 x 4 Hex Cap Screw 1
This accessory is designed for installation on the A-Frame drawbars only. For use with
Torsion based LittleGiant Trailer™ models only.
Copyright © 2013 Let’s Go Aero, Inc. ACC3070rev0614