Lenze 8210 series - Manual (Page 58)

Configuration
7-8 UONu_^MPMQ
L
Code IMPORTANT Possible settings Name Code IMPORTANT
Info Selection Lenze
Name
C125
¿*
LECOM baud rate -0- -0- 9600 baud
-1- 4800 baud
-2- 2400 baud
-3- 1200 baud
-4- 19200 baud Only for LECOM
applications
C142
¿
Start condition -1- -0- Automatic start inhibited,
flying-restart circuit inactive
-1- Automatic start, if term. 28 HIGH,
flying-restart circuit not active
-2- Automatic start inhibited,
flying-restart circuit active
-3- Automatic start, if term. 28 HIGH,
flying-restart circuit active
C144
¿
Chopper-
frequency
reduction
821X/822X/824X -1- -0- No chopper-frequency reduction
-1- Automatic chopper-frequency
lowering when J
max
- 10 °C
C161
*
Current fault Only display
C162
*
Last fault Only display
C163
*
Last but one fault Only display
C164
*
Last but two fault Only display
C170
¿
TRIP-reset
selection
-0- TRIP-reset by pressing the STP key or
LOW signal at ctrl. enable
-1- Auto-TRIP-Reset
C171 Delay for
Auto-TRIP-Reset
0 0 {1s} 60
C178
*
Operating time Only display
C179
*
Mains switch-on
time
Only display
C377 Gain Zk-voltage
detection
822X/824X
Should only
be changed
by the Lenze
Service!
C500
*
Display factor
application datum
numerator
821X/822X/824X 2000 1 {1} 25000
C501
*
Display factor for
process variable
denominator
821X/822X/824X 10 1 {1} 25000
Show/Hide Bookmarks