Lenze EMF2180IB - Manual (Page 60)

9 Parameter reference
60
Lenze · EMF2180IB communication module (EthernetCAN) · Communication Manual · DMS 5.0 EN · 07/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C1209
C1210
The IP addresses are divided into 3 classes:
x: complete octet
Parameter | Name:
C1209 | Read out CAN baud rate
Data type: INTEGER_32
Index: 23366 = 0x5B46
Code C1209 can be used to determine which baud rate was detected on the CAN bus.
When "16" is displayed, no data are exchanged on the CAN bus.
Selection list
(read only)
0 500 kbit/s
1 250 kbit/s
2 125 kbit/s
3 50 kbit/s
4 1000 kbps
5 20 kbit/s
16 not detected
 Read access  Write access  CINH  PLC-STOP  No transfer
Parameter | Name:
C1210 | IP address
Data type: UNSIGNED_32
Index: 23365 = 0x5B45
The IP address is the identification number of a device in the network. Each network node receives a unique address
in the network. Compared to the MAC-ID, the IP address is a logic address that can be changed via software.
By default, the address 0.0.0.0 is set. Since this is not a valid IP address, the device searches for a free address in the
subnetwork 169.254.xxx.xxx at the start, as specified by the APIPA process.
The IP addresses always consist of 4 octets (subcodes 1 ... 4). In order to improve readability, the octets are separated
from each other by points (e.g. 128.133.10.123).
The first octet determines the network class. The network class specifies the number of available hosts in a network.
Note:
The data are only accepted when the mains has been switched the next time.
The following function is available from version 1.7 onwards!
After the code has been changed, the IP address and subnet mask combination is checked with regard to its validity.
If the IP address and subnet mask combination is invalid, the gateway is set to the IP address 0.0.0.0, and DHCP is
set to dynamic assignment of the IP address (code C1228 ).
Setting range (min. value | unit | max. value)
0 255
Subcodes Lenze setting Info
C1210/1 0 IP address 1
C1210/2 0 IP address 2
C1210/3 0 IP address 3
C1210/4 0 IP address 4
 Read access  Write access  CINH  PLC STOP  No transfer
Class IP address classes Maximum number of hosts
a 01.x.x.x - 126.x.x.x 16.777.214
B 128.x.x.x - 191.x.x.x 65.534
C 192.x.x.x - 223.x.x.x 254