Landoll 6230 Disc - Manual (Page 45)

ASSEMBLY INSTRUCTIONS
3-19
Wing Frames
1. Place the wing frames on top of the wing gang
assemblies and attach using 3/4-10 x 2 hex head cap
screws and hex lock nuts (See Figure 3-10.).
2. Assemble the tire and wheel assemblies to the wing
frames.
3. Attach the front gauge wheel assemblies to the wing
frames using 1-8 x 6 hex head cap screws, gauge
wheel spacers, and hex lock nuts. Securely tighten
the mounting screws to eliminate any slack and
unnecessary wear.
4. Mount the wing stabilizer brackets to the wing frames
using u-bolts and hex lock nuts. See Figures 2-1
thru 2-4 for placement dimensions.
NOTE
On 21’-29’ models the wing stabilizers mount to the sides
of the wing frame. On 30’-36’ models the wing stabilizers
mount to the tops of the wing frames.
5. Install a 1/4 x 3 roll pin in one end of each wing lock
pin. Insert the pin in the round hole of the front wing
stabilizers and secure with a 3/16 hair pin.