Landoll 6230 Disc - Manual (Page 31)

ASSEMBLY INSTRUCTIONS
3-5
Leveler Assembly
1. Install a hardened steel wear bushing in the leveler L
link (See Figure 3-2.)
2. Attach the leveler L link to the front mount of the
center frame with a 1-8 x 4-1/2 hex head cap screw
and hex lock nut.
3. With a 1-8 x 4 hex head cap screw and hex lock nut
attach the leveler ball joint link to the leveler L link.
4. Connect the bottom end of the leveler ball joint link to
the rear mounting holes of the hitch using a 1-8 x
4-1/2 hex head cap screw and hex lock nut.
NOTE
When the hitch is in the upper mounting position, the
leveler ball joint link is mounted in the lower holes. When
the hitch is in the lower position, the link is mounted in the
top mounting holes. See “Hitch Adjustment” on
page 4-12 for proper adjustment.
5. Install plastic wear flange bearings into both ends of
the 15-1/4” leveler links. Insert the bushings on the
flat side of the link.
6. Insert plastic wear flange bearings into the round
tube end of the 8” leveler links. Insert the wear
bushing on the tube side of the link.
7. Slide one end of the 15-1/4” link over the leveler
screw assembly. Slide the large end of the 8” link
over the other link and secure with a 1” washer and
5/16” x 2-1/2 spring slotted pin. Repeat this for the
other side of the leveler screw assembly.
8. Attach the bottom end of the 8” leveler links to center
frame mount located in the middle of the frame using
1" x 7-7/8" leveler pin, washers, and 5/16" x 2-1/2"
spring slotted pins.
9. Secure the rear of the 15-1/4” leveler links to the top
holes of the mounting plates located on the center lift
using 1" x 7-7/8" leveler pin, washers, and 5/16" x
2-1/2" spring slotted pins.
NOTE
If using a harrow attachment, see “Variable Ratio
Adjustment” on page 4-11 on which mounting hole to
use.