Koolance RM2-4U - Manual (Page 20)

15 User Manual
Each cooler kit contains clamps to secure
tubing to the cooler’s nozzles. Thread a
clamp onto each tube before connecting it to
the cooler nozzle.
Attach by squeezing the tube while pushing
firmly over the nozzle. The tubing should
completely cover the nozzle.
If you are finding it difficult to connect some
tubes (such as to the CPU cooler), try
temporarily stretching-out the tube end by
inserting need-nose pliers.
Connecting Tubes
Continue connecting all of your
coolers in the system until there
are no longer any open tube ends.
Although it is most common for
tubing from the heat exchanger to
go directly to the CPU cooler,
liquid may circulate in either
direction through the coolers.