Power control board – Koolance RM2-4U User Manual
Page 17
12
Power Control Board
You may begin the installation of your Koolance system by mounting a power
supply in the chassis. The liquid cooling system requires approximately 8-10W
from any standard ATX power supply.
Connect a 12-volt 4-pin Molex plug from the power supply to the Power Control
Board. Without this important connection, the Koolance system will NOT operate.
CAUTION
:
The Power Control Board is vital to system operation. A
12V 4-pin plug from the power supply must remain connected to the
circuit at all times while the computer is in use.
!
Connecting PC2 & IPC Systems