KD Scientific Adagio Control Software for Legato Series Manual - Manual (Page 14)

Adagio User Manual © 2010 KD Scientific
5619-001 Rev B
14
Press the Start identification button to determine the pump model
connected to the serial port with the address number specified in the
previous step.
An activity bar serves as a visual signal of the progress of the
identification process
At the end of the identification process, the assistant shows the result
indicating the detected pump model name and version.
The automatic identification process requires the pumps to send the
version identifier. For Legato pumps please check that the “echo”
function is disabled before trying to identify them. In order to disable
the “echo” function, please refer to the Legato User’s Manual.
Once the pump has been identified, press the Next button to move
the assistant towards the last step.
If the restrictions applicable to the quantity of pumps within a chain
(see “2.1. Compatible Network Topologies”) are exceeded, a
warning message is shown and the assistant does not advance to
the next step.
3.1.3. Selecting the mounted rack model and number of
syringes
The final step of the Pump Configuration Assistant asks you to
select a specific pump model from a list. This will inform Adagio of the
syringe rack model being used.