JUMO 902930 Wtrans Transmitter RTD Temperature Probe with Ex approval Operating Manual - Manual (Page 37)

37
5 Installation
5.3 Installing the wall holder and transmitter
Figure 10: Installing the wall holder and transmitter
Proceed as follows to install the wall holder and the transmitter:
1 Holes for wall holder 4 Plastic clamp
2 Clamping bush (use for different protection tube
diameters) 5 Transmitter protection tube
3 Cylinder head screws M5
Step Activity
1 Fasten the wall holder to the wall using three suitable screws and dowels (not included in
the scope of delivery).
2 Insert the clamping bush into the wall holder from above.
Align the guide with the open end in the direction of the wall.
Slightly tighten the two cylinder head screws M5 with a screwdriver.
3 From above, insert the protection tube into the clamping bush and tighten with the two cyl-
inder head screws M5.