INFICON Sensistor ISH2000 Hydrogen Leak Detector - Manual (Page 34)

Hydrogen leak detector Sensistor ISH2000 - Operating Manual
34 OM-Sensistor ISH2000-EN-201304
EN
* For password to access Service Setting , please contact INFICON.
Audio Base Frequency
This sets the lowest audio base frequency tone in Measuring and Locating Mode.
Set Clock
Real time set as hh:mm:ss. Hours and minutes can be adjusted. Seconds will
automatically be set to 00 when hours and minutes have been set. Clock runs even
when detector is disconnected from the power supply.
Set Date
Real time clock date set as YY-MM-DD. Clock runs even when detector is
disconnected from the power supply.
Data Output*
The Sensistor ISH2000 is equipped with a serial (RS232) printer port for data output.
See “Printer port” on page 39.
* Not in ILS500 Mode
Info
Contains information about software versions, Serial number, and Internet contact
information.
8.12 Service Settings
Service Settings contains important settings that the customer should not change
without supervisor guidance. To enter Service Settings menu a password is required.
Contact your local supplier for help.
Calibration
(settings) Yes Yes Yes Yes
Locating Mode
Settings Yes Yes
Measuring Mode
Settings Yes Yes Yes Yes
Display Settings Yes Yes
General Settings Yes Yes Yes Yes
Service Settings* Yes Yes Yes Yes Yes
Password
protected
settings/
functions
Non
(No password has
been set)
Standard
Standard
+
Password
Protected
Calibration
High
High
+
Password
Protected
Calibration