INFICON HLD6000 Refrigerant Leak Detector Interface Description - Manual (Page 11)

ASCII Protocol 11
*MEASure:U3V3 +3.3 V supply [V] 201 R
*MEASure:U5 +5 V supply [V] 218 R
*MEASure:UIRSOURCE IR source voltage [V] 179 R
*MEASure:UPROBE Probe test voltage 177 R
*READ leak rate in selected unit 128 R
*READ:G/a leak rate in g/a 129 R
*READ:LB/yr leak rate in lb/yr --- R
*READ:MBAR*l/s leak rate in mbar*l/s --- R
*READ:OZ/yr leak rate in oz/yr --- R
*READ:PA*m3/s leak rate in Pa*m3/s --- R
*RST:CALHistory Clears calibration history W
*RST:ERRORHistory Clears error history W
*RST:FACTORY Sets all parameters to factory default 1161 W
*SERVICE:READBuffer Read service buffer:
current number (359 ... 0)
IR-sensor raugh data (signed 16 bit integer)
leak rate in cg/a (float)
diff press rough value p1 (signed 16 bit integer)
diff press rough value p2 (signed 16 bit integer)
Imod in cg/a with 1000 offset (unsigned 16 bit integer) R
*SLEEP Switch from Measure to Standby 2 W
*STANDBY Switch from Measure to Standby 2 W
*STArt Switch from Standby to Measure 1 W
*STATus status of HLD6000 (RUNUP, MEAS, STANDBY, PROOF,
CAL_INTERN, CAL_EXTERN, ERROR) Status
word R
*STATus:BUSModule Status Bus-Module:
SETUP
NW_INIT
WAIT_PROCESS
IDLE
PROCESS_ACTIVE
ERROR
UNKNOWN
EXCEPTION 330 R
*STATus:BUSModule:ADDRess Field bus address 326 R
*STATus:BUSModule:BAUDrate Baud rate at field bus 327 R
*STATus:BUSModule:DHCP DHCP (ENABLED, DISABLED) 340 R
*STATus:BUSModule:ERRORCnt Four error counters, format “a,b,c,d”
a: Discarded commands
b: Discarded responses
c: Serial reception errors
d: Fragmentation errors 329 R
*STATus:BUSModule:EXCEPtion Exception Code of Bus module as hex value 328 R
*STATus:BUSModule:IPADDRess IP address of BM1000 (IP based field buses only) 337 R
*STATus:BUSModule:IPGATEWay IP address of gateway 339 R
*STATus:BUSModule:IPSUBNETMask IP subnet mask (IP based field buses only) 338 R
*STATus:BUSModule:STATIONName BM1000 station name (PROFINET IO only) 336 R
Command Meaning
Relates
to LD
cmd. no.
Read /
Write