INCRA Miter 5000 with Sled & Telescoping Fence - Manual (Page 2)

Carefully unpack Components
After carefully unpacking all components, remove the (2) phillips flat head screws and rectangular nuts that secure the (2) Miter Sled
base panels and steel miter bar. Also, remove the phillips head screw that secures the aluminum miter bar to the protractor head.
Fig. 1
depicts the components included. Identify each part as listed below:
note: If you have purchased the Miter3000 to Miter5000 Conversion Kit, begin with the instructions titled “Converting Miter3000
Miter Gauge to Miter5000 Miter Sled” on page 8, then continue with the assembly instructions.
Parts list
The following components are not included with
Miter3000 to Miter5000 Conversion Kits:
K. Hardware Pack C-05
L. Flip Shop Stop & Instructions
M. Extender Bar
N. 4" Flip Fence Extender
O. 32" Flip Fence
A. Left Sled Base w/Protractor Head Assembly
(on Miter3000 to Miter5000 Conversion Kits,
Protractor Head Assembly not included)
B. Hardware Pack C-09
C. Hardware Pack C-07
D. Hardware Pack C-08
E. Steel Miter Bar
F. Aluminum Miter Bar
G.
3 ⁄ 16 " Ball End Hex Tool
H. Large Clamping Knob
I. Right Sled Base
J. Miter5000 Owner’s Manual (not pictured)
FIG. 1
A.
B.
C.
D.
E.
F.
G.
I. J. (not pictured)
O.
N.
M.
K.
L.
H.
2