HYDAC HMGWIN 3000 - Manual (Page 28)

HMGWIN 3000 English Page 28
Edition 06/2007 – V02 R01
Click on “Full size“ to see the whole range again.
By clicking on “Display settings“ a window will pop up.
o
You can choose whether the time or one of the sensors is to be scaled along
the X axis. This enables a P/Q diagram to be rendered on line, for example.
o
By clicking on the checkbox for left Y axis and right Y axis you can determine
which channels are to be displayed on the Y axis (right- or left-hand side of the
graph).
o
In the lower section you can hide and show individual channels. By manually
entering the “Current display range“ you can assign a different Y scaling to
the individual channels.
o “Accept“ means the changes made by you are applied without closing the
window.
o
Click “OK“ to apply the changes made by you and to close the window.
o
Click “Cancel“ to close the window without the changes being applied.
If you select “End recording“ cancels the current measurement and restarts it
again.
To finish recording, click on “End automatic“ and then “End recording“, in case
no more trigger events occur.
3.7.3 Communications Settings
To change the data link settings, click first on the actual link and then on “Disconnect“ and
then on "Communications settings“. Now browse for the HMG again as described in sec-
tion Fehler! Verweisquelle konnte nicht gefunden werden. and establish the link.