GeoDesy Pronto X Series User Manual
Page 29
GeoDesy Kft.
29
E-mail: [email protected]
H-1116 Budapest, Kondorfa str. 6-8. Telefon: 06-1-481-2050
Fax.: 06-1-481-2049
Auto-focus setup (AF)
Automatic divergence corrections:
•
Enabled (auto): adjust beam size to the best level according to the remote
level.
•
Disabled (manual): It disables the automatic adjustment routine, and lets the
user adjust the beam size by using the „STEP” buttons.
Last activity: which the AF (auto focus) has done.
•
idle: AF was not active..
•
setting default: saves the standard settings.
•
moving default: return to default settings.
•
moving to open: opens to widest beam.
•
increasing remote load: the AF adjusts the laser beam to increase remote
level.
•
decreasing remote load: the AF adjusts the laser beam to decrease remote
level.
•
optimizing remote load: the AF adjusts the laser beam to optimal remote
level.
Remote is visible: The remote side is visible or not.
Remote lost time: Shows time when remote level got lost.
Remote detector level: Shows receiving level in Volt and number of units on LCD.
Manual focus control: After setting the Manual Focus controls you can adjust the
manual focus by clicking on the „STEP” buttons. You can increase the beam size, by
clicking on the plus numbers or you can decrease it by clicking on the minus. The
amount of the increase or the decrease depends on the number of steps .