GeoDesy Pronto X Series User Manual
Page 20
GeoDesy Kft.
20
E-mail: [email protected]
H-1116 Budapest, Kondorfa str. 6-8. Telefon: 06-1-481-2050
Fax.: 06-1-481-2049
Please press the button and look at the LCD scren!
1. screen
Loc (local level): Local Received level
Rem (remote level): Remote Sites Received level
Op-optimal
Ov-overload
2.screen
HeadSN: Laser head serial number.
0000001
3.screen
Temperature
TT°C
4.screen
-AF mode position manual 000
-AF mode auto
Here shows that the auto fucus with is enabled or disabled.
5.screen
Note: Geodesy FSO shall not be responsible for any failures from improper handling
of the device. If any other screw than the coarse lockers or the fine adjustment is
moved, might decrease the stability of the installation.
Trick for the reliable alignment
Please note that the beam has a powerfull ring on the side of the head and easily can be
set to this ring but this is far not as big as the core
part of the beam. So every time you have an
alignment please make sure that when you see the
maximum LED s or a relativly high received level.
Keep on moving to determine where the core part of
the beam is. This can be done easily by looking at
the received level you will see that the received level moves up then it will start move
down than up again. During this time you just had the head moving into one direction. If
you have any doubt on how to do the alignment please contact your distributor for further
help. Or contact GeoDesy FSO technical support.