GeoDesy Pronto X Series User Manual
Page 19
GeoDesy Kft.
19
E-mail: [email protected]
H-1116 Budapest, Kondorfa str. 6-8. Telefon: 06-1-481-2050
Fax.: 06-1-481-2049
6.2.2 Fine tuning
1. Site A start moving the
laserhead
with
the
horizontal fine adjustment
screw by looking at the
Remote
end
received
level
2. Using the fine adjustment
screws, lighten as many
LEDs as possible
3.
Repeat step 1-2 on Site
B.
4.
If necessary try step 1-2
on both sites again.
6.2.3 Meanings of the LCDs
Power:
The head is powered up.
RX-OK:
Received beam is good for communication.
TP Lk:
Copper link between the head and the
Network equipment.
R-LS:
The recived signal form the remote end is modulated and .
RV/T-LS:
Remote end is visible for the management system and there is TP connected to
remote end – same as TP-Lk but displays it on the remote end.
Top Level LEDs:
Local Received level
Bottom Level LEDs:
Remote Sites Received level
10
th
LED:
The 10 th LED has three functions showing that the recived level reached its
optimum this is green, it maximum it is yellow or the receiver got saturated and this
is red