GeoDesy Pronto X Series User Manual
Page 24
GeoDesy Kft.
24
E-mail: [email protected]
H-1116 Budapest, Kondorfa str. 6-8. Telefon: 06-1-481-2050
Fax.: 06-1-481-2049
RX OK: this information is showing that the receiver is enabled. It basically means
that there is valid signal with necessary strenght is received in the local end.
Device setup
The device setup screen leads you to the main monitoring options. Here the alarms
can be set and main information about the Laser head.
Device name: uniqe identifier of
the device
Managed head: Type of the laserhead
Detector alert level: when the
received level reach this value,
the alarm will be triggered.
Temperature alert level: when the temperature reach this value, the alarm will be
triggered.
Auto MDI/MDI-X: this enables
the
Auto
setting
for
the
MDI/MDI-X, some old switch
types
might
report
incompatibility here it can be switched off. (Auto MDI/MDI-X can be turned off even
in the Xs systems)
NPASD (if avialable):
if the reciver does not detect sufficient light power, then in the
head would switch off the network connection signal. Note: During this perid the
100MB/s laser heads MGM will not be available
Motherboard Firmware version: This is the version number of the Firmware
File image version: Version number of the file image
Motherboard Serial number: Mainboard serial number inside the head (Not the same
as the Head Serial Number)
Head Serial number: Serial number of the unit. Should be the same number as the
one on the back of the unit. If the number is missing or not match up with the one on
the back, during activation this is the number you will have to let the support know.