GeoDesy Pronto X Series - Manual (Page 13)

GeoDesy Kft. 13 E-mail: [email protected]
http://www.geodesy-fso.com
H-1116 Budapest, Kondorfa str. 6-8. Telefon: 06-1-481-2050
Fax.: 06-1-481-2049
5 The mounting bracket
In the following chapter you will find detailed description of the bracket fastenings.
5.1 Mounting brackets for the X Series
GeoDesy FSO provides the mounting bracket and all the necessary components
for X series units. A simple fixing technique of this bracket can be seen on the
following figure, required tools are as follows:
- drilling machine
- 10 mm wrench
Bracket sizes:
Length: 463mm
Leg Width: 263mm
Head Width: 130mm
Drill size: 10mm wall drilling
Installation steps:
•
Place the bracket on the wall
•
Mark the wall with a permanent marker
•
Use your 10mm wall drill to drill all of the holes into the wall
•
Clean the holes
•
Place the wall-plugs into the holes (please note that some times you need to
use hammer to put the wall-plugs into the hole, if you have to please be
careful not to break the wall-plug
)
•
Place the bracket to the wall an line it up to the holes
•
Put the screws into the wall-plug through the hole on the leg of the bracket
(please see the figure above)
•
Tighten up the screws
Packet list for the bracket:
3pcs 8x110 screw for bracket fixing
3pcs 8x100 plastic wall-plug for bracket fixing