GeoDesy Pronto X Series User Manual
Page 18
GeoDesy Kft.
18
E-mail: [email protected]
H-1116 Budapest, Kondorfa str. 6-8. Telefon: 06-1-481-2050
Fax.: 06-1-481-2049
Alignment of the
X series
The first step after the unit was placed to the
bracket, and turns the units facing each
other.
On the back of the receiver you can find
the LEDs for the local received level and
the remote received level. This help will be very useful because as soon as you have
received – which is very easy to achieve – you can see the effect of your local sides
movement to the other side. For further information please check the Meanings of
the LEDs chapter.
6.2.1 How to use the alignment
base
1. Loose the Coarse locker on the
horizontal as well as on the
vertical side with a 10mm
spanner
2.
Move the head left - right up
down you should use the built in
telescope to lit up a few LEDs on
the remote end.
3.
When you have lined the unit up
to a rough position lock the
coarse locker with a 10mm
spanner.
4.
Repeat step 1-4 on the remote
end.
5. On the bottom of the unit you can find fine tuning screws one for horizontal
and one for vertical.
6. No tightening is needed on any other screw than the coarse locker.